Skip to main content

IMIS

A new integrated search interface will become available in the next phase of marineinfo.org.
For the time being, please use IMIS to search available data

 

[ report an error in this record ]basket (1): add | show Print this page

one publication added to basket [100701]
Determination of the rate of production and dissolution of biosilica in marine waters by thermal ionisation mass spectrometry
Corvaisier, R.; Tréguer, P.; Beucher, C.; Elskens, M. (2005). Determination of the rate of production and dissolution of biosilica in marine waters by thermal ionisation mass spectrometry. Anal. Chim. Acta 534(1): 149-155
In: Analytica Chimica Acta. Elsevier: New York; Amsterdam. ISSN 0003-2670; e-ISSN 1873-4324, more
Peer reviewed article  

Available in  Authors 

Keywords
    Aquatic sciences > Marine sciences > Earth sciences > Oceanography > Chemical oceanography
    Chemical compounds > Silicon compounds > Silica
    Isotopes > Silicon isotopes
    Marine/Coastal

Authors  Top 

Abstract
    A new method is described for a precise and simultaneous determination of the rate of production and dissolution of biosilica in marine waters, using isotopic dilution technique. No HF or F2 is required for chemical preparations as the change in isotopic composition is measured on silica producing SiO2 ions. The seawater sample flask is spiked with 30Si(OH)4 (<10% of increase in situ concentration) and incubated in in situ conditions. At the end of incubation, changes of the 30Si:28Si ratios in particulate and liquid phases are measured by using a thermal ionisation mass spectrometer Finnigan THQ. The relative analytical precision of the isotopic ratio measurements is <0.5%. The limit of detection of the change in isotopic ratio during incubation is 0.02 atom%. The overall repeatability determined on eight subsamples (average production: 0.23 μM day−1; average dissolution: 0.07 μM day−1) is ±0.02 and ±0.01 μM day−1 for production and dissolution, respectively. Using mass and isotopic balances of the particulate and dissolved phases in the incubation flask, the best estimates for production and dissolution rates are calculated iteratively. This method was applied to 112 samples of marine waters (production, range: 0.00–2.38 μM day−1; dissolution, range: 0.00–1.18 μM day−1).

All data in the Integrated Marine Information System (IMIS) is subject to the VLIZ privacy policy Top | Authors