Skip to main content

IMIS

A new integrated search interface will become available in the next phase of marineinfo.org.
For the time being, please use IMIS to search available data

 

[ report an error in this record ]basket (0): add | show Print this page

Wave loads on rubble mound breakwater crown walls in deep and shallow water wave conditions
Nørgaard, J.Q.H.; Andersen, T.K.; Burcharth, H.F. (2013). Wave loads on rubble mound breakwater crown walls in deep and shallow water wave conditions. Coast. Eng. 80: 137-147. http://dx.doi.org/10.1016/j.coastaleng.2013.06.003
In: Coastal Engineering: An International Journal for Coastal, Harbour and Offshore Engineers. Elsevier: Amsterdam; Lausanne; New York; Oxford; Shannon; Tokyo. ISSN 0378-3839; e-ISSN 1872-7379, more
Peer reviewed article  

Available in  Authors 

Keywords
    Rubble-mound breakwaters
    Superstructures
    Wave load
    Marine/Coastal
Author keywords
    Crown-wall; Wave height distribution

Project Top | Authors 
  • Innovative coastal technologies for safer European coasts in a changing climate, more

Authors  Top 
  • Nørgaard, J.Q.H.
  • Andersen, T.K.
  • Burcharth, H.F.

Abstract
    The semi-empirical formulae by Pedersen (1996) for wave loads on vertical front faces of stiff crown walls are based on model tests with deep and intermediate water wave conditions. A new series of model tests performed at the same test facility as used by Pedersen has revealed that the formulae by Pedersen overpredict the loads in shallow water wave conditions. This paper presents a modification/expansion of the formulae to cover loads in both deep and shallow water wave conditions. The modification is based on a series of 162 physical model tests on typical rubble mound breakwaters with crown wall superstructures. The implementation of shallow water wave conditions in the formulae is done by modifying the term for wave run-up to be dependent on the incident wave height distribution. Moreover, the adjusted formulae provide more accurate estimates of the wave loads on free walls without front armour protection. Pressure transducers with very high eigen-frequencies were used in the present model tests as opposed to the transducers applied by Pedersen which in some cases seem to have been affected by dynamic amplifications.

All data in the Integrated Marine Information System (IMIS) is subject to the VLIZ privacy policy Top | Authors