Skip to main content

IMIS

A new integrated search interface will become available in the next phase of marineinfo.org.
For the time being, please use IMIS to search available data

 

[ report an error in this record ]basket (0): add | show Print this page

Wave forcing over an intertidal mussel bed
Donker, J.; van der Vegt, M.; Hoekstra, P. (2013). Wave forcing over an intertidal mussel bed. J. Sea Res. 82: 54-66. https://dx.doi.org/10.1016/j.seares.2012.08.010
In: Journal of Sea Research. Elsevier/Netherlands Institute for Sea Research: Amsterdam; Den Burg. ISSN 1385-1101; e-ISSN 1873-1414, more
Peer reviewed article  

Available in  Authors 

Keywords
    Bed shear stress
    Energy transfer > Energy dissipation > Wave dissipation
    Properties > Surface properties > Roughness > Bed roughness
    Marine/Coastal

Authors  Top 
  • Donker, J.
  • van der Vegt, M.
  • Hoekstra, P., more

Abstract
    The Mosselwad project studies the stability and opportunities for restoration of mussel beds in the Wadden Sea. In this context we seek to predict mussel bed stability with respect to hydrodynamic forcing. To make accurate predictions with models, field experiments are needed to determine relevant processes and to establish representative estimates for model parameters. These parameter values were determined by a six week campaign on a relatively young mussel bed in the Wadden Sea. During this period wave height, period, propagation velocity, dissipation and flow velocities were measured. From these measurements values for the total rate of energy dissipation and the rate of wave energy dissipation were estimated. Results show a large increase in measured bed shear stress over the mussel bed compared with the uncovered parts of the intertidal flat. This is caused by the large roughness of the mussels. The turbulent kinetic energy was highabove the covered parts of the bed. From the dissipation rate of TKE values for the corresponding bed shear stress and roughness height were estimated. These estimates were subsequently applied to calibratea wave model which was used to determine the spatial distribution of the wave forcing. Model results show that the bed shear stress decreases over the mussel bed but increases behind the bed. Furthermore, a model study on the situation before the mussel bed settled shows that a minimum in wave forcing coincides with the seaward edge of the bed. This suggests that the bed is currently located in the optimal location with respect to wave forcing.

All data in the Integrated Marine Information System (IMIS) is subject to the VLIZ privacy policy Top | Authors