Skip to main content

IMIS

A new integrated search interface will become available in the next phase of marineinfo.org.
For the time being, please use IMIS to search available data

 

[ report an error in this record ]basket (0): add | show Print this page

Preparation method for solid samples with low nitrogen content for spectrometric nitrogen-15 analysis
Goeyens, L.G.; Stichelbaut, L.W.; Post, E.J.; Baeyens, W.F.J. (1985). Preparation method for solid samples with low nitrogen content for spectrometric nitrogen-15 analysis. Analyst 110: 135-139
In: The Analyst. Chemical Society: London. ISSN 0003-2654; e-ISSN 1364-5528, more
Peer reviewed article  

Available in  Authors 

Keywords
    Analytical techniques > Spectroscopic techniques > Emission spectroscopy
    Marine/Coastal

Authors  Top 
  • Goeyens, L.G., more
  • Stichelbaut, L.W.
  • Post, E.J.
  • Baeyens, W.F.J., more

Abstract
    A new procedure for the conversion of bound nitrogen into nitrogen gas, applicable to solid material, is described. It embodies two main stages: the catalytic ammonification of the sample and the consecutive transformation of ammonium to molecular nitrogen by the modified Dumas method. The first step of the preparation is carried out in a quartz reactor, filled with granular nickel, at a temperature of 700°C, the ammonia gas produced being trapped in sulphuric acid. In the second step, this solution is neutralised, dried and subjected to the Dumas combustion.The addition of reagents does not influence the results of the measurements. Spectrometric 15N percentage abundances are converted into mass spectrometric "true" 15N percentage abundance by using two straight calibration lines, one over the lower range of abundances (0.36-2.4% 15N) and the other over the range 2.4-11% 15N. A relative error smaller than 2% for the recalculation of the standards substantiates the accuracy of the conversion .The method has been applied to the study of nutrient uptake by marine phytoplankton. The assimilation rate of the labelled compound was determined on samples of 2.5 mg of particulate matter with a maximum nitrogen content of 0.2 mg.

All data in the Integrated Marine Information System (IMIS) is subject to the VLIZ privacy policy Top | Authors