Skip to main content

IMIS

A new integrated search interface will become available in the next phase of marineinfo.org.
For the time being, please use IMIS to search available data

 

[ report an error in this record ]basket (0): add | show Print this page

Evaluation of electro-coagulation-flocculation for harvesting marine and freshwater microalgae
Vandamme, D.; Pontes, S.C.V.; Goiris, K.; Foubert, I.; Pinoy, L.J.J.; Muylaert, K. (2011). Evaluation of electro-coagulation-flocculation for harvesting marine and freshwater microalgae. Biotechnol. Bioeng. 108(10): 2320-2329. http://dx.doi.org/10.1002/bit.23199
In: Biotechnology and Bioengineering. Wiley-Blackwell: New York. ISSN 0006-3592; e-ISSN 1097-0290, more
Peer reviewed article  

Available in  Authors 

Keywords
    Marine/Coastal; Fresh water
Author keywords
    coagulation; microalgae; dewatering; aluminum; electrodes; electrolytic flocculation

Authors  Top 
  • Vandamme, D., more
  • Pontes, S.C.V.
  • Goiris, K., more
  • Foubert, I., more
  • Pinoy, L.J.J.
  • Muylaert, K., more

Abstract
    Although microalgae are considered as a promising feedstock for biofuels, the energy efficiency of the production process needs to be significantly improved. Due to their small size and low concentration in the culture medium, cost-efficient harvesting of microalgae is a major challenge. In this study, the use of electro-coagulation–flocculation (ECF) as a method for harvesting a freshwater (Chlorella vulgaris) and a marine (Phaeodactylum tricornutum) microalgal species is evaluated. ECF was shown to be more efficient using an aluminum anode than using an iron anode. Furthermore, it could be concluded that the efficiency of the ECF process can be substantially improved by reducing the initial pH and by increasing the turbulence in the microalgal suspension. Although higher current densities resulted in a more rapid flocculation of the microalgal suspension, power consumption, expressed per kg of microalgae harvested, and release of aluminum were lower when a lower current density was used. The aluminum content of the harvested microalgal biomass was less than 1% while the aluminum concentration in the process water was below 2?mg?L-1. Under optimal conditions, power consumption of the ECF process was around 2?kWh?kg-1 of microalgal biomass harvested for Chlorella vulgaris and ca. 0.3?kWh?kg-1 for Phaeodactylum tricornutum. Compared to centrifugation, ECF is thus more energy efficient. Because of the lower power consumption of ECF in seawater, ECF is a particularly attractive method for harvesting marine microalgae.

All data in the Integrated Marine Information System (IMIS) is subject to the VLIZ privacy policy Top | Authors