Skip to main content

IMIS

A new integrated search interface will become available in the next phase of marineinfo.org.
For the time being, please use IMIS to search available data

 

[ report an error in this record ]basket (0): add | show Print this page

Pumping fluid mud: theoretical and experimental considerations
Berlamont, J. (1989). Pumping fluid mud: theoretical and experimental considerations. J. Coast. Res. Spec. Issue(5): 195-205
In: Journal of Coastal Research. Coastal Education and Research Foundation: Fort Lauderdale. ISSN 0749-0208; e-ISSN 1551-5036, more
Peer reviewed article  

Available in  Author 

Keywords
    Anchorages > Harbours
    Dredging
    Feasibility
    Pumping
    Sediments > Clastics > Mud > Fluid mud
    Water bodies > Inland waters > Canals > Ship canals
    ANE, Belgium, Brugge, Zeebrugge [Marine Regions]
    Marine/Coastal
Author keywords
    Layered mud deposits

Author  Top 

Abstract
    In many cases maintenance dredging in harbors and access channels could be much cheaper and easier if the deposited mud could be pumped using fixed equipment. Therefore the feasibility of pumping fluid mud was examined. It is found that homogeneous mud can be pumped efficiently up to densities of 1150 kgm-3 (for the Zeebrugge (Belgium) mud). For higher densities the influence radius of the pumps becomes very small. A 1-D model can be used to determine the static equilibrium slope and the equilibrium profile of the mud-water interface. Layered mud deposits are more difficult to remove by pumping, since after each pumping cycle a layer of mud remains. As a consequence, layered mud deposits must be homogenized before pumping. This can be done by water jetting, air bubble mattresses or propeller mixers.

All data in the Integrated Marine Information System (IMIS) is subject to the VLIZ privacy policy Top | Author