Skip to main content

IMIS

A new integrated search interface will become available in the next phase of marineinfo.org.
For the time being, please use IMIS to search available data

 

[ report an error in this record ]basket (0): add | show Print this page

Field and laboratory measurements of sediment erodibility: a comparison
Schaaff, E.; Grenz, C.; Pinazo, C.; Lansard, B. (2006). Field and laboratory measurements of sediment erodibility: a comparison. J. Sea Res. 55(1): 30-42. https://dx.doi.org/10.1016/j.seares.2005.09.004
In: Journal of Sea Research. Elsevier/Netherlands Institute for Sea Research: Amsterdam; Den Burg. ISSN 1385-1101; e-ISSN 1873-1414, more
Also appears in:
Friedrichs, M.; Graf, G.; van Duren, L.A. (Ed.) (2006). Exchange processes at the sediment-water interface: contributions by participants of the Second BioFlow Conference. Journal of Sea Research, Spec. Issue 55(1). Elsevier: Amsterdam. 1-85 pp., more
Peer reviewed article  

Available in  Authors 

Keywords
    Controlled conditions
    Erosion
    Erosion rate
    Forces (mechanics) > Stress (mechanics) > Shear stress
    In situ measurements
    Sediments
    Water bodies > Coastal waters > Coastal landforms > Coastal inlets > Estuaries
    MED, France, Rhone Estuary [Marine Regions]
    Marine/Coastal
Author keywords
    erosion; critical shear stress; erosion rate; laboratory flumes; in situmeasurements; Gulf of Fos

Authors  Top 
  • Schaaff, E.
  • Grenz, C.
  • Pinazo, C.
  • Lansard, B.

Abstract
    The erosion of fine-grained cohesive sediments is a ubiquitous phenomenon in marine and estuarine environments. Critical shear stress and erosion rates are predominant variables in transport mechanics. This study presents a comparison between in situ and laboratory measurements of sediment erodibility. The main goal was to assess the reliability of critical shear stress of erosion determined in a laboratory flume. The laboratory experiment allowed us to define the erodibility of sediments sampled at a reference station in the Gulf of Fos. This site is frequently influenced by Rhône river inflows. Two different values of critical shear stress of erosion were determined, the lowest (τc1 = 0.02 ± 0.002 N m-2) related to the erosion of the fluff layer, and the highest (τc2 = 0.05 ± 0.005 N m-2) to a more consolidated layer or to coarser particles. These values of critical shear stress were very close to commonly in situ based estimates of fluff critical shear stresses, which ranged between 0.02 and 0.05 N m-2. The comparison with acoustic backscatter data recorded during a field cruise in autumn attested in a qualitative way to the reliability of the critical shear stress of erosion determined in our laboratory flume. The erosion coefficients determined during this study, varying between 3.4 10-6 and 7.5 10-6 kg m-2 s-1, were used to calculate in situ erosion rates. Between 6 and 9 October, the mean erosion rate at the reference station was 20 g m-2 h-1 and maximum values reached 65 g m-2 h-1. The calculated erosion rates were used to predict in situ variations in suspended sediment concentration (SPM). The predicted increase in SPM was 14 mg l-1, close to the measured increase in SPM (10 mg l-1). The results from this initial attempt to compare in situ and laboratory erosion measurements are encouraging but further investigation is needed. Potential organic matter fluxes determined in our flume were around 1.7 mmol PON m-2 h-1 and 115 μmol POP m-2 h-1. An estimation based on these results showed that the organic material introduced into the water column by erosion amounted to between 12 and 200% of the daily pelagic primary production. This is considerable and should be considered in biogeochemical studies of coastal systems.

All data in the Integrated Marine Information System (IMIS) is subject to the VLIZ privacy policy Top | Authors